€0.00
Excl. 19% VAT , excl. Shipping Cost
Article
BRR-3842558006
Manufacturer Nr.
3842558006
Connection kit active belt bridge 160 L
The active belt bridge is used as transfer unit for bridging the conveyor trench between the basic unit and the Return unit between section start or end and a third-party conveyor or in connection drive
- Only for flat conveyor chain t7
- The active belt bridge is driven by a transmission (on the drive or Return unit side)
- Suitable for conveyed materials from approx. 80 mm in length (depending on the speed, position of the center of gravity, product friction, etc.)
- Installation possible on both the drive and Return side (make sure to use the correct L/R version)
- Not permitted for wet operation, rough ambient conditions or sharp-edged products
- Accumulation not permitted
- Load depending on the speed (see diagram)
- The speed of the adjacent conveyor should be approximately the same to prevent premature wear
- Simple transmission of the drive force using hexagonal hollow shafts integrated into the base unit or Return unit as standard
- Can be retrofitted into a standard configuration at any time
- Easy replacement of the belt from the top
Condition on delivery | Some assembly required |
Weight [kg] | 2.4 |
Material | Aluminum/non-rusting steel 1.4301/PA/PE/ABS/PUR |
Size [b] [mm] | 160 |
Scope of delivery | Incl. fastening material, transmission and protective cover |
Weight [kg] | 2.4 |
Manufacturer Nr. | 3842558006 |
---|---|
Manufacturer | Bosch Rexroth |
Weight | 0.100000 |