Design permits installation with a section gap from a = 90 mm when space is limited
Suitable for mounting on an ST 2/… section with a profile width of 45 mm or an ST 2/…-H section with a profile width of 50 mm
4 positions, can be moved to pneumatically: – Upper, lower position and latch in the extended and retracted state
3 positions can be sensed: – Top, bottom and extended stop rail – Can be combined with WT 2, WT 2/F, WT 2/H and WT 2/F-H
Product description
The slide stop is used in a transverse section that connects more than two longitudinal sections and that requires supplementary stops. A lift transverse unit can feed in the workpiece pallet onto the longitudinal section when the slide stop is activated. The pneumatically lowerable slide stop is extended to the upper end position when the system is depressurized. Mounted inside the tracks, directly on the conveyor section.
Technical data
Possible installation location for VA 2/D-130
During outfeeding on parallel section
Possible installation location for VA 2/D-130
As a node point
Article
3842549503
3842559001
Max. total weight of workpiece pallet
mG
kg
130
130
ESD
ESD
yes
Max. operating temperature
T
°C
60
Material entry
Housing: Aluminum, hard anodized Latch: Steel
Housing: Aluminum, hard anodized Latch: Steel
Mass
m
kg
15
15
Required compressed air connection
p
bar
4 ... 6 bar
4 ... 6 bar
Pneumatic push-in fitting
Ø
mm
6
6
Symbols/Circuit diagrams
1)
Not included in the scope of delivery
Dimensions
VA 2/D-130 Slide Stop
VA 2/D-130 Slide Stop
Accessories
Recommended accessories
Sensor M12x1
M12x1 sensor with rated sensing range SN = 4 mm, overall length 45 mm
Clamping Holder
Delivery notes
Condition of Delivery
Fully assembled
Scope of delivery
Incl. all fastening material to mount on ST 2/... conveyor section
Right-angle connector for the air connections in Quickfix design